Machine Information
69
Machine Status
4
2
Enter the feature number to be set
in [Item Number] using the numeric
keypad.
3
Select [Confirm] as necessary.
4
Select [Change Value].
5
Enter [New Value] using the
numeric keypad.
6
Select [Save].
îš„Item number
Enter the item number of the feature to be set.
îš„Current Value
When you enter [Item Number], the currently set value appears.
îš„New Value
Enter a new value.
Store/Delete Programming
For ESC/P-K and HP-GL/2 emulations, you can register settings in the memory.
You can register up to 20 print modes for ESC/P-K and HP-GL/2 emulations.
1
Select [Store/Delete Programming].
2
Select [Store Current Selections] or
[Delete].
3
Select the memory number to be
stored or to be deleted.
îš„Store Current Selections
Stores the current selections. If you select a number already stored, its settings will be
overwritten with the new settings. The overwritten settings cannot be restored.
îš„Delete
When you select [Delete] and then select the number to be deleted, the number will be
deleted.
Important • The deleted numbers cannot be restored.
Default Programming
You can start the printer using the settings stored in the memory as default settings.
1
Select [Default Programming].
2
Select [Factory Defaults] or
[Custom Settings].
3
When you select [Custom
Settings], select the memory
number to be used.
To Next Page
Loading...
Need help?
General
