QD002-07 1. Safety Guideline
NXT Setup Manual 3
Check that there is nobody inside the machine when
working on the machine with two persons or more
• Verify that nobody is within or near the machine before
operating the machine. Operating the machine may cause
injury to the person who is carrying out maintenance.
Do not approach a machine that has stopped moving
• There are times during automatic operation when the machine
may appear to have stopped while it is waiting for a board,
waiting for the next machine, reading marks, transmitting data,
etc. In such cases, once certain conditions are fulfilled, the
machine will begin moving again automatically, so care should
be taken. Only approach the machine after the EMERGENCY
STOP button has been pressed.
• When the message "Ready" displays at the machine display,
the machine will begin to move once certain conditions are
satisfied. Keep in mind that the machine will begin to move
regardless of whether these conditions are satisfied
intentionally or inadvertently.
Do not place hands near the main conveyor
• Hands or other body parts may be caught in the machine.
Always perform maintenance work after turning OFF the
machine power supply.
• Failure to observe this may result in sudden machine
movements or electric shock, and is therefore extremely
dangerous.
Do not insert or remove connectors while power is being
supplied to the machine
• Removing or inserting connectors while power is supplied to the
machine may not only cause damage to the machine, but may
also cause electrical shock.
Stay clear from the machine when it is being lifted
• Never put hands or feet under the machine when the machine
is being raised by means of a jack or other device for leveling or
transport.
WARNING
To Next Page
Loading...