QD002-07 1. Safety Guideline
NXT Setup Manual 7
When working on the base in the opening above the waste tape
box, ensure that no one pulls out a module
• The module may pinch, sever, or cause serious injury.
When working on the base in an opening with the cover off,
ensure that no one pushes or pulls out in the module
• The module may pinch, sever, or cause serious injury.
Do not rotate the module lock knob to [UNLOCK] when a module
is loaded on the MCU.
• If the module moves on the MCU, it could pinch and sever fingers,
and if it falls from the MCU it could cause severe injury or death.
There is a limit to the number of modules that can be pulled out
safely at the same time. (Maximum: Four M3 modules on an 8M
base, or two M3 modules on a 4M base.)
• If the maximum is exceeded, the entire machine may fall over to the
front, possibly resulting in serious physical harm. This is especially
true when the front leveling bolts have not been adjusted.
Do not modify the module stopper mechanism on the base and
remove the module without mounting the MCU first.
• The module could fall from the base causing severe injury or death.
Do not stare at the vision process light sources with naked eyes.
Wear protective glasses.
• Eye damage may be caused by the light.
Stay off of the base.
• Failure to do so could result in injury.
When handling the MCU, watch out for corners and protrusions.
• Failure to do so could result in injury.
Always be ready to apply the caster brake when handling the
MCU.
• Always use the caster brake when stopping an MCU loaded with a
module.
WARNING
To Next Page
Loading...