1. Safety Guideline QD002-07
8 NXT Setup Manual
When lifting a backup plate, be careful to not put your hands in
the areas between the plate, width-changing ball screw, and
hexagonal shaft. Also, be careful to not cut your hands on the
corners of the conveyor rails.
• Failure to do so could result in injury.
Do not lift a backup plate if you are not strong enough, and
maintain correct lifting posture if you do lift a backup plate.
• Because the backup plates are very heavy, lifting them incorrectly
could result in back or other injuries.
Never insert hands or other body parts into the duct of the waste
tape disposal unit.
• There is a very sharp cutter blade. Exercise extreme caution
especially when carrying the unit.
Two or more people should carry the waste tape disposal unit.
• Maintenance of the waste tape disposal unit is usually accompanied
by removing the unit from the machine. Two or more people should
carry the unit because it is very heavy.
Ensure that the work bench where the waste tape disposal unit
is placed is flat.
• The unit may fall to the ground if the work bench is tilted, causing
personnel injury and the machine damages.
Do not touch the Y-axis linear motor in a M6S module
immediately after production is stopped.
• Contact with the shaft or coil section could cause burns. The shaft
and coil section of the Y-axis linear motor remain at high
temperatures even after production is stopped.
People with a heart pacemaker should stay clear of the Y-axis.
• A heart pacemaker could malfunction due to the strong magnetic
field generated by the linear motor for the Y-axis in M6S modules.
Do not disassemble the linear motor used for the Y-axis in the
M6S module.
• Absolutely do not disassemble the linear motor coil and shaft parts.
Injury and/or machine damage may occur by magnetic parts
shooting out due to the strong force of the magnets.
WARNING
To Next Page
Loading...