Getting started
Getting started
Gettingstarted
Please observe the safety information in the "Important notes", Page 10 chapter.
Unpacking and checking the delivery
It is recommended not to throw away the original packaging material! It may be
required for reshipment at some later dat e.
PackagingContentsofd eliveryPackaging,
► Unpack all the individual parts.
► Check the contents of the package for any visible damage ca used during transport.
► Check whether the delivery conforms to the details in the delivery no te.
► Should you discover that the delivery does not correspond to the delivery
note, notify your local sales outlet immediately.
Steps for initial setup
Preparingforfi rstuse, overviewPreparingforu se,
Only a few steps are necessary to put your new device into operation for the first time:
• Select a location for device and set up device
• Connect extern al devices such as mouse, keyboard and monitor
• Check the voltage at the mains outlet and connect the device t o an electrical outlet
• Switch the device on
You will learn more about the individual steps in the following sections.
External devices
If you have received other external devices in addition to your own device (e.g.
a printer), do not connect the se until after the initial insta llation. The following
sections describe how to connect these external devices.
Drives and b oard s
If you have received drives or boards with your device, please do not install
them until aft e r first-time setup. How to install drives and boards is described
in the "
System expansions", Page 34 chapter.
14 Fujitsu
To Next Page
Loading...
