Fujitsu CELSIUS M730 - Removing a Module Holder with Reader; Removing the Reader from the Module Holder

System expansions
Removing a module holder w ith reader
• Requirement: The casing is open (see "Opening the casi ng", Page 36).
► Disconnect the ca bles connected to the module holder.
1
1
► Remove the screws (1).
► Slide the module holder out of the casing in the direction of the arrow (2).
► Remove the reader from the modu le holder (see "
Removing the reader from
the module holder", Page 44) and reinstall the mod ule holder (corresponds to
"
Installing a module holder wit h reader", Page 43).
or
► Remove the rea
der from the m odule holder (see "
Removing the rea der from the module
holder " , Pag
e 44) and install the metal and plastic co ver in the drive bay.
► Close the casing (see "
Closing the casing" , Page 37).
Removing the reader from the module holder
1
1
► Undo the screws (1).
► Pull the rea der out of the mo dule holder
in the direction of the arrow.
44 Fujitsu