Getting started
Settingupthedevice
WorkstationErgonomicDevice
When installing your device, please read the r eco mmendations and safety
notes in the "Safety/regulations" manual.
We recommend that you p lace your device on a surface which is not slippery. In
view of the m any different finishes and varnishes use d on furniture, it is possible
that the rubber feet will mark the surface they stand on.
Depending on the location of your device, bothersome vibrations and noises may
occur. To prevent this, a dista nce of at least 10 mm / 0.39" should be m aintained
from other devices on casing sides without ventilation su rfaces.
In order to avoid overheating, do not cover the ve ntilation areas
of the monitor or the device.
A minimum distance of 200 m m / 7.87" from th e device must be
observed for ventilation areas.
Do not stack several devices on top of each other.
Do not expose the device to extreme ambient conditions (se e "
Technical data", Page 71,
section "Ambient conditions"). P rotect the device against dust, humidity and heat.
Connecting the m achine to the mains
Mainsadapter,
2
1
► Connect the mains cable to the machine (1).
► Plug th
e mains plug into a three-pin socket (2).
After
the mains power cable h as been attached, the device automatically switches
itsel
f on for a few seconds to run a system test, then sw itches off again.
Fujitsu 15
To Next Page
Loading...
