System expansions
System expansions
Upgrades,Device,Systemexpansi onComponentsServicing
Repairs to the device must only be performed by qualified technicians. Incorrect repairs
may grea tly endanger the user ( electric shock, fire risk) and will inva lidate your w arranty.
After consulting the Hotline/Help Desk, you may remove and install the components
described in this manual yourself.
As the device has to be shut down i n order to install/deinstall system hardw are
components, it is a good idea to print out the r elevan t sections of this chapter beforehand.
The following illustrations may differ slightly from your device, depending on i ts confi guration level.
If further documentation was delivered with your device, please also read this thro ugh carefully.
In addition, b efore removing or installing system comp onents, please pay attention to the following:
The d evice must be switched off when installing/removing th e system
expansions and may not be in energy-saving mode.
Remove the power plug before opening the device.
Be careful that no wires become trap ped when removing or installing components.
When installing components that b eco me very hot, make sure that the maximum
permissible temperature of the components in operation is not exceeded.
An update of the BIO S may be required for a system expansion or hardware
upgrade. Further in formation can be found in the BIOS help section or if
necessary in the Technical Manual for the mainboard.
34 Fujitsu
To Next Page
Loading...
