Getting started
Connecting external devices to the USB ports
USBdevices,USBport,Externaldevices,Devices,
You can connect a wide range of external devices to the USB p orts (e.g.
printer, scanner, modem or keyb oard).
USB devices are hot-pluggable. This means you can connect and disconnect
USB cables while your device is switched on.
Additional information can be found in the documentation for the USB devices.
► Connect the data cable to the external device.
► Connect the data cable to one of the USB ports on your device.
Device drivers
External USB devices which you connect to one of the USB ports don’t usually
need their own drivers because the software required is already included
in the operating s ystem. If the device requires separate software, please
follow the instructions in the manufacturer ’s manual.
To ensure the transmission capacity of USB 2.0, the cable from the external USB
device to the USB port of your device must not be longer than 3 m.
The USB port for USB 3.0 is located on the front of your device.
Switching on for the first time: installing the software
Installing,Software,Installing,
Once the installation has been started the device must not be switched
off, unless the installation has been completed.
During installation, the device may only be rebooted when you are requested to do so!
The insta llation will otherwise not be carried out correctly and the contents
of the hard disk must be completely restored.
If the devic
e is integrated into a network, the user and server details as well as
the network
protocol are required during the software installation.
Contact yo
ur network administrator if you have any questions about these settings.
When you sw
itch on the device for the first time, the supplied software
is instal
led and configured. Plan a reasonable amoun t of time for this,
as this pr
ocess must not be interrupted.
You may n
eed the licence numb er for Windows during the installation. The licence
number i
s located on a label on your device.
20 Fujitsu
To Next Page
Loading...
