System expansio ns
Replacing the processor
► Open the casing (see "Opening the casing", Pa ge 36).
► Remove th e heat sink (see "
Removing the heat sink", Page 65).
► Replace the processor as described in the manual for the mainboard.
► Install the heat sink again (see "
Install ing the heat sin k", Page 65).
► Close the casing (see "
Closing the casing" , Page 37).
Installing and removing heat sinks
Removing the heat sink
The shape an d position of the heat sink are device-dependent.
► Open the casing (see "
Opening the casing", Pag e 36).
► Remove the hood of th
e hard disk fan and the hard disk fan itself (see
"
Remove the hard dis
k f an", Page 68).
► Undo the screws on the heat sink.
► Lift the heat sink o
ut of the casing.
Yo u can now replace the processor.
Installing the h
eat sink
► Open the casing (see "Opening the casing", Pa ge 36).
► Reinstall the
heat sink so that the air flow is fed towards the back of the
casing (see ar
row on the heat sink).
► Tighten the screws.
► Reinstall th
e hard disk fan an d the hood of the hard disk fan (see "
Install
the hard disk
fan", Page 69).
Never attac
h or detach fans during operation. T his can cause problems
controlli
ng the mainboard fan .
Fujitsu 65
To Next Page
Loading...
