System expansio ns
Install the hard disk fan
1
2
2
► Insert the fan in the casing (1) and ensure that the catches (2) en gage.
► Connect the fan cable to the mainboard.
a
1
► Position the hood in the c asing and slide the grooves of the hood into the guides on the fan (a).
► Carefully fold the hood down (1) until you feel it latch into place.
Installing a 4 port SAS upgrade ROM
Proceed as follows to install the 4 port SAS upgrade ROM mass storage controller:
► Open the casing (see "
Opening the casing", Pag e 36).
► Plug the upgrade ROM connector into the mainboard – refer to the mainboard manual for details.
► Close the casing (see "
Closing the casing" , Page 37).
Fujitsu 69
To Next Page
Loading...
