Fujitsu CELSIUS M730 - Removing the Module Holder; Screwing the Reader Onto the Module Holder

System expansions
Removing the module ho lder
• Requirement: open the casing (see "Opening the ca sing", Page 36).
► Disconnect the ca bles connected to the module holder.
1
1
► Remove the screws (1) on the m odule holder.
► Slide the module holder out of the casing in the direction of the arrow (2).
Screwing the reader onto the module holder
2
2
a
a
1
► With the component side facing downwa rds,
slide the reader in the direction of arrow (1)
into the guide on the m odule holder (a).
► Fasten the reader with the screws (2).
42 Fujitsu