Getting started
Switchingonforthefirst time: installing the software
Installing,Software,Installing,
Once the installation has been started the device must not be sw itched
off, unless the installation has been completed.
During installation, the device may only be rebooted when you are requested to do so!
The installation will otherwise not be carried out correctly and the contents
of the hard disk must be completely restored.
If the device is integrat
ed into a network, the user and server details as well as
the network protocol ar
e required during the software installation.
Contact your network ad
ministrator if y ou have any questions about these settings.
When you switch on the d
evice for the first time, the supplied software
is installed and config
ured. Plan a reasonable amount of time for this,
as this process must n
ot be interrupte d.
You may need the lic
ence number for Windows during the installation. The licence
number is located o
n a label on your device.
Switch on the monitor and the machine
In order to avoid overheating, do n ot cover the ventilation areas
on the m onitor or the device.
► Switch on the monitor (see operating instructions for the monitor).
► Press the on/off button on the front of the m achine.
The o perational display will lig ht up and the machine will start.
Fujitsu 19
To Next Page
Loading...
