System expansions
Installing a hard disk drive
• Requirement: remove the protective grille (see " Removing the protective grille", Page 55).
EasyChange rails for a s eco n d hard disk drive are mounted on the drive cage.
► Secure the EasyC hange rails on the side of the hard disk by inserting the upper pins
of the EasyChange rail in the corresponding holes on the hard disk.
By default, the wiring for standard installation (max. four 2
1
/
2
-inch drives) is installed.
If you wish to install other or different drives, use the supplied cables.
56 Fujitsu
To Next Page
Loading...
