System expan sio ns
Installing and removing the accessible 5
1
/
4
inch
drive (Ultra S lim, top drive b
ay)
The following instructions apply only to the installation and removal of an
accessible drive in Ultra Slim format, in the top drive bay.
Installing an accessible drive
1
3
2
► Remove the screws (1).
► Push the drive carrier a few centimetres out of the casing in the direction of the arrow (2).
► Pull the drive carrier c ompletely out of the c asing in the direction of th e arrow (3).
Do not dispose of the cover of the Ultra Slim drive bay. For cooling and
protection against fire you must refit the cover if you remove the drive again
later (see "
Removing an accessible drive", Page 41 ).
► Remove the cover of the Ultra Slim drive bay.
Fujitsu 35
To Next Page
Loading...
