System expan sio ns
Installing a new assembly kit (for expansion
from 4 to max. 8 drives)
If you wish to upgrade your d evice to up to 8 drives, replace the standard assembly
kit C78 with the optional expansion assembly kit C76.
In addition to the cable for the basic configuration, you will also need an expansion cable.
Assignment of expansion assembly kit:
EP0 / P0
EP1 / P1
EP2 / P2
EP3 / P3
EP4 / P0*
EP5 / P1*
EP6 / P2*
EP7 / P3*
Assignment of expansion assembly kit with
connected connectors:
Basic configura tio n cable:
• Slot EP0 = C onnector P0 (Boot-HDD)
• Slot EP1 = C onnector P1
• Slot EP2 = C onnector P2
• Slot EP3 = C onnector P3
Expansion cable:
• Slot EP4 = Connector P0*
• Slot EP5 = Connector P1*
• Slot EP6 = Connector P2*
• Slot EP7 = Connector P3*
Replacing the assembly kit
• Requirem ents:
There are not any hard disk drives installed in the drive bays.
Otherwise you must fi rst remove the hard disk drives.
• The casing is open (see "
Opening the casing", Page 33).
• The hard d isk fan is removed (see "
Remove the hard disk fan", Page 67).
If you wish to use an installation kit for your hard disks which is other th an that which
was installed in your device i n the factory, proceed as follows:
Only the relevant components are shown in the following illustrations
for reasons o f simplification.
Fujitsu 51
To Next Page
Loading...
