System expan sio ns
Installing and removing the accessible 5
1
/
4
inch
drive (standard size, bottom
drive bay)
The following instructions apply only to the installation and removal of an
accessible drive in standard size, in the bottom drive bay.
Fitting the drive cover for the 5
1
/
4
inch driv e
• Requirem ent: The casing is open (see section "Opening the casi ng", Page 33).
To use the latch function of the accessible 5
1
/
4
inch drive, you must fit the corresponding
drive cover before installing the drive i n the casing. Proceed as follows:
2
3
1
► Unlock the drive cover (1).
► Push the drive m etal plate upwards (2) so it is released from the catches with which it is secured.
► Lift the drive cover away from the casing (3).
1
► Connect the drive cover to the drive (1).
Fujitsu 39
To Next Page
Loading...
