System expan sio ns
1
► Slide the hard disk drive with the EasyChange rails into the drive cage in the direction of the
arrow (1). Ensure that the label on the 3½" hard disk drive is facing the side cover to be opened.
If you are installing a 2½" hard disk drive, ensure that the label is on the top.
► Connect the cables to the hard d isk drive.
It may be necessary to modify the entry for the drive in the BIOS Setup.
Removing a hard disk
The principles fo r installing/removing hard disks for the device as described below are identical
for all types of hard disk. Only the size and alignm ent of the hard disk in the casing may
vary (install either ho rizont ally or vertica lly depending on the hard disk type).
The following images illustrate the installation of a 3
1
/
2
" drive.
Removing the hard disk drive
► Open the casing (see "Opening the casing", Page 33).
► Remove the hard disk front panel (see "
Removing the hard disk front panel", Page 54).
► Remove the protective grille (see "
Removing the protective grille", Page 55).
Fujitsu 57
To Next Page
Loading...
