System expan sio ns
Removing a m odule holder with reader
• Requirem ent: The casing is open (see "Opening the ca sing", Page 33).
► Disconnect the cables connected to the module holder.
1
1
3
2
► Remove the screws (1).
► Push the module holder a few centimetres out of the casing in th e direction of the arrow (2).
► Pull the module holder completely out of the casing in the direction of the arrow (3).
► Remove the reader from the module holder (see "
Removing the reader from
the module holder", Page 46) and reinstall the module holder (corresponds to
"
Installing a module holder with read er", Page 44).
or
► Remove the reader from the m odule holder (see "
Removing the reader from the
module holder", Pag e 46) and install a blind cover in the drive bay.
► Close the ca
sing (see "
Closing the casing", Page 3 4).
Fujitsu 45
To Next Page
Loading...
