System expan sio ns
Removing a board
► Open the casing (see "Opening the casing", Page 33).
Board
► Disconnect the cables connected to the board.
1
1
2
1
► With long PCI bo
ards, remove the upper part of the card holder at the front fan i n order to be able
to release the b
oard at the front fan during removal: Push the locking lug on the upper, removable
part of the car
d holder in the direction of the arrow (1). Lift the card holder away from the fan (2).
1
2
► Push the mounting clip (1) towa rds the slot co ver to unlock it, then move
it towards the back panel of the device.
► Pull the board out of the slot in the direction of the arrow (2).
► Place the board in suitable packaging.
Fujitsu 63
To Next Page
Loading...
