System expan sio ns
Installing t h e rear fan
2
1
► Position the fan i
n the casing (1) and ensure that the catch (2) engage s
in the openings on
the back of the device.
► Connect the fan c able to the mainboard.
Replacing the processor
► Open the casin
g(see"
Opening the cas ing", Page 33).
► Remove th e heat sink (see "
Removing the heat sink", Page 71).
► Replace the p
rocessor as described in the m anual for the mainboard.
► Install the heat sink again (see "
Installing the heat sink", Page 72).
► Close the c
asing (see "
Closing the casing", Page 3 4).
Installing and removing heat sinks
Removing the heat sink
The shape an d position of the heat sink are d evice-dependent.
► Open the casing (see "
Opening the cas ing", Page 33).
► Remove the hood of th e hard disk fan and th e hard disk fan itself (see
"
Remove the hard disk fan", Page 67).
► Undo the screws on the heat sink.
► Lift the heat sink ou t of the casing.
You can now replace the processo r.
Fujitsu 71
To Next Page
Loading...
