Important notes
FCC Compliance Statement
If the device complies with the FCC regulations, the FCC sign can be found on the type rating plate.
FCCClassBComplianceState
ment
The following statement applies to th e products covered in this manual, unless otherwise specified
herein. The statement for other products will appear in the accompan ying do cume ntation.
NOTE:
This equipment has been teste d and found to comply with the limits fo r a "Class B" digital
device, pursuant to Part 15 of the FCC rules and meets all requirements of the C anadian
Interference-Causing Equipment Standard ICES- 00 3 fo r digital apparatus. These limits are
designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in strict accordance with the inst ructio ns, may cause harm ful interference to r adio
communications. However, there is no guara ntee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning th e equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving ant enna.
• Increase the sep
aration between equipment and the receiver.
• Connect the e quipm ent into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the de
aler or an experienced radio/T V technician for help.
Fujitsu Techn ology Solutions GmbH is not responsible for any radio or television interference
caused by un authorized modifications of this equipment or the substitution or attachment
of connecting cables and equipment other than those specified by Fujitsu Technology
Solutions GmbH. The correction of interferences caused by such unauthorized modification,
substitution or attachment will be the responsibility of the user.
The use of shielded I/O cables is required when connecting this equipment to any an d all optional
peripheral or host devices. Failure to do so may violate FCC and IC ES rules.
Fujitsu Technology Solutions 11
To Next Page
Loading...
