Troubl esho ot ing and tips
The device cannot be switched off w ith the ON/OFF switch.
Cause
Remedy
The device has not been switched on with the
ON/OFF switch.
► Press the ON/OFF switch again.
System crash ► Keep the on/off switch pressed for at least 4
seconds until the machine switches off.
Caution: This can lead to a loss of data!
This procedure does not allow the operating
system to shut down in an orderly way. The next
time the system is started there may well be
error messages.
Monitor remains blank
Cause
Remedy
Monitor is switched o ff. ► Switch your monitor on.
Power saving has been activated (screen is
blank)
► Press any key on the keyboard.
or
► D e ac tiv a te the screen saver. If
necessary, enter the ap propria te
pass word.
Brightness control is set to dark ► Adjust the brightness control. F or de tailed
information, please refer to the operat ing
manual supplied with your monitor.
Power cable not connected
► Switch off the monitor and the device.
► Check that the monitor power cable is
properly connected to the monitor and to
a grounded mains outlet or to the monitor
socket of the device.
► C heck that the device power cable is
properly p lugged into the device and a
grounded m a ins outlet.
► Sw itch on the monitor and the device.
Monitor cable not connected
► Switch o
ff the monitor and the device.
► Check that the m onitor cable is properly
connected to the device and monitor.
► Switch
on the monitor and the device.
Fujitsu Technology Solutions 29
To Next Page
Loading...
