Fujitsu CELSIUS W410 - Installing the Memory Card Reader; Removing the Memory Card Reader

System expan sio ns
Installing the memory ca rd reader
2
2
1
► Push the memory car
d reader into the casing in the direction of the arrow (1).
► Fasten the memory card reader with the screws (2).
► Connect the cable
s to the memory card reader and to the mainboard.
Make sure the pola
rity is correct.
► Close the casing (see "
Closing the casing", Page 36).
Removing the memory card reader
► Open the casing (see "Opening the casing" , Page 35).
► Disconnect the ca bles connected to the memory card reader.
1
1
2
► Remove the screws (1).
► Slide the memory card reader out of the casing in the direction of the arrow (2).
► Install a blind cover in the drive bay.
► Close the casing (see "
Closing the casing", Page 36).
Fujitsu Technology Solutions 45