Getting started
Installing the lower cover
2
1
3
1
Device with device
cover (1), w ith installed lowe r
cover (2)
Device with device
cover (1) an d visible type
plate (3), without
lower cover.
The device is equipped with a device cover (1) on the underside. The device cover is divided
into two: during operation, the lower cover (2) is inserted in the device cover.
When your de vice is delivered, the lower cover (2) is not yet installed o n the underside
of the device, instead it is enclosed with the system, so that you can see the type rating
plate (3) and the software licence in formation during the initial start-up.
The type rating plate and the software licence are affixed on t he device cover and are
normally not visible underneath the installed lower cover.
To install the lower cover before the initial start-up and to be able to use the
device for the first time, proceed as follows:
► Turn the device over and place it on a stable, flat and clean surface. If necessary, lay an
anti-slip cloth on this surface to prevent the device from being scratched.
14 Fujitsu Technology Solutions
To Next Page
Loading...
Need help?
General