Getting started
Connecting external devices
Read the d ocumentation on the extern al device before connecting it.
With the exception of USB devices, always remove all power plugs
before con necting external devices!
Do not connect or discon nect cables during a thunderstorm.
Always take hold of the actual plug. Neve r unplug a cable by pulling the cable itself.
Connect and disconnect the cables in the order described below.
Connecting the cables
► Turn off all power and equipment switches.
CordCable,
► Remove all power plugs from the grounded mains outlets.
► Connect all the cables to the device and the external devices. Please make sure that you
always observe the safety notes provided in "
Important notes", Page 9.
► Plug all data communication cables into the appropriate sockets.
► Plug all power cables into the grounded m ains outlets.
USB devices are hot-pluggable. This means yo u can connect and disconnect
USB cables while your device is switched on.
Additional in formation can be found i n "
Connecting external devices to the USB
ports", Page 23 and in the documentation for the USB devices.
Disconnecting the cables
► Switch off al
l affected devices.
Cable,
► Remove all power plugs from the grounded mains outlets.
► Unplug all d
ata communication cables from the appropriate sockets.
► Disconnect all of the cables from the device and from the external devices.
Fujitsu Technology Solutions 21
To Next Page
Loading...
Need help?
General