Fujitsu ETERNUS DX200 S3 Setup Guide

Chapter 5 Host Interface Management
5.2 Modify Port Parameters
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
73
2 Set the parameters for all of the selected ports.
The settings of port parameters vary depending on the port mode ("When the port mode is "CA"" (page
73), "When the port mode is "RA" or "CA/RA"" (page 74), or "When the port mode is "Initiator"" (page
74)).
■ When the port mode is "CA"
The main setting items are as follows.
● Port Settings
• Port
• Connection
• Set Loop ID
• Loop ID
• Transfer Rate
• Multiple selections can be made from FC ports that have the same "Type" and "Port Mode".
• Multiple ports can be set with the same or with different parameters in a single operation. To set
parameters to multiple ports, select the target ports and specify the parameters for each port.
After the specification is complete, click the [Modify] button.

Fujitsu ETERNUS DX200 S3 Specifications

General

Model	ETERNUS DX200 S3
Category	Storage
Number of Controllers	2
Drive Types Supported	SAS, Nearline SAS
RAID Levels	0, 1, 5, 6
Power Supply	Redundant
Management Software	ETERNUS SF
Host Interfaces	Fibre Channel, iSCSI, SAS
Form Factor	Rack-mounted