8.2.3 Disk Partition Settings
Set up disk partitions to use the specified LUNs for the ETERNUS DX.
The volumes are recognized as disks in order, starting from the volume that is set for LUN0.
For example, if LUN0 is recognized as Disk 1, LUN1 is recognized as Disk 2 and LUN2 as Disk 3.
Perform the settings as shown below.
Drive
File system
that is to be
created
LUN Volume No. Volume name Type Capacity (*1)
F NTFS 0 0 main Standard 1TB
G RAW 1 1 sdv0 SDV (1TB)
H RAW 2 2 sdv1 SDV (1TB)
I RAW 3 3 sdv2 SDV (1TB)
J RAW 4 4 sdv3 SDV (1TB)
K RAW 5 5 sdv4 SDV (1TB)
L RAW 6 6 sdv5 SDV (1TB)
M RAW 7 7 sdv6 SDV (1TB)
*1: The capacity that is displayed in "( )" is the copy source capacity.
For the operation volume (Standard), perform "
■ Operation Disk Settings" (page 130) in "8.2.3.2 Disk Set-
tings" (page 130).
For the volume for generation copy (Snap Data Volume), perform "■ SnapOPC+ Destination Settings" (page
133) in "8.2.3.2 Disk Settings" (page 130).
8.2.3.1 Disk Recognition
The following procedure explains how to create a disk partition.
1 Select [Disk Management] from [Computer Management].
2 If the [Initialize Disk] screen appears, confirm that all the disks are selected and click the [OK] button.
Then proceed to Step 6.
Select the checkbox for eight disks in this example.
When Windows Server 2008 Enterprise is used, [Initialize Disk] does not appear. Perform the steps from
Step 3 onwards.
Chapter 8 SAN Connection Settings
8.2 Server Connection Setup
126
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0
To Next Page
Loading...
