Fujitsu ETERNUS DX60 S3 - Rear; Figure 1.2 Front View of a 3.5 Type Controller Enclosure; Figure 1.3 Rear View of a Controller Enclosure (When Only One Controller Is Installed)

■
3.5" Type
Figure 1.2 Front View of a 3.5" Type Controller Enclosure
1
3 3
2
1. Operation panel
2. 3.5" drive
3. Flange cover
1.1.2 Rear
This section provides the names of the components in the rear of a controller enclosure.
•
When only one controller is installed
Figure 1.3 Rear View of a Controller Enclosure (When Only One Controller is Installed)
1
3456
8 9
6 7 2
1. Controller (CM#0)
2. Cover
3. PWC port
4. Drive interface (OUT) port
5. LAN (RMT) port
6. LAN (MNT) port
7. Host interface (CA#0)
8. Power supply unit (PSU#0)
9. Power supply unit (PSU#1)
Chapter 1 Component Names
1.1 Controller Enclosures
19
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0