Fujitsu ETERNUS DX60 S3 - Remote Support (by REMCS) Setup

(5) Check the setting completion message and click the [Done] button.
The screen display returns to the remote support screen.
4 Confirm the connection of the ETERNUS DX and the AIS Connect server in the remote support center.
(1) In [Action], click [Test Server Connectivity].
A confirmation screen appears.
(2) Click the [OK] button.
The connection with the server is checked. The result is displayed in the [Test Server Connectivity
Result] screen.
(3) Click the [Done] button.
The screen display returns to the remote support screen.
5 Send the test event to confirm that the event is reported to the AIS Connect server.
(1) In [Action], click [Send AIS Connect Test Event].
A confirmation screen appears.
(2) Click the [OK] button.
The test event is sent to the AIS Connect server. The result is displayed in the [Send AIS Connect
Test Event Result] screen.
(3) Click the [Done] button.
The screen display returns to the remote support screen.
6.3.2 Remote Support (by REMCS) Setup
When using the remote support function by REMCS, perform the environment settings for connecting to the
remote support center, and register the customer information to send to the remote support center.
If the AIS Connect function is being used, disable the AIS connect function and then start the remote sup-
port (by REMCS) setup.
1 On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2 In [Category], click [REMCS] in [Remote Support].
The [Support Information] tab screen of the [Remote Support] screen appears.
3 In [Action], click [Setup Remote Support].
The [Setup Remote Support] screen appears.
Chapter 6 Monitoring Settings
6.3 Remote Support Setup
94
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0