Fujitsu ETERNUS DX60 S3 - Hot Spare Registration; Figure 5.11 Volume Information after Creation

The volume information after the copy data destination volume is created is as shown below.
Figure 5.11 Volume Information After Creation
5.7.5 Hot Spare Registration
Register the hot spare for the failure of a drive.
The following two types of hot spare are available:
•
Global Hot Spare
This is available for any RAID group.
•
Dedicated Hot Spare
This is only available to the specified RAID group (one RAID group).
For a RAID group that contains important data, assign "Dedicated Hot Spare" in order to preferentially use
the hot spare.
Chapter 5 General Settings
5.7 RAID Configuration Settings
78
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0