Fujitsu ETERNUS DX60 S3 - Drive Enclosure (3.5 Type); Front; Rear; Figure 1.5 Front View of a Drive Enclosure

1.2 Drive Enclosure (3.5" Type)
Drives and an operation panel are installed in the front of the drive enclosure. I/O modules and power supply
units are installed in the rear.
1.2.1 Front
This section provides the names of the components in the front of a drive enclosure.
Figure 1.5 Front View of a Drive Enclosure
1
3 3
2
1. Operation panel
2. 3.5" drive
3. Flange cover
1.2.2 Rear
This section provides the names of the components in the rear of a drive enclosure.
•
When only one I/O module is installed
Figure 1.6 Rear View of a Drive Enclosure (When Only One I/O Module is Installed)
34
1
56
2
1. I/O module (IOM#0)
2. Cover
3. Drive interface (IN) port
4. Drive interface (OUT) port
5. Power supply unit (PSU#0)
Chapter 1 Component Names
1.2 Drive Enclosure (3.5" Type)
21
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0