•
To help with LAN cable management and prevent incorrect connections, attach labels to the LAN cables
and make a note of connection origins and destinations.
•
When connecting LAN cables, check the connector orientation and then firmly push it all the way in.
When disconnecting LAN cables, depress the tab, then pull out the connector.
This section uses a controller enclosure with two controllers as an example to explain the connection pro-
cedure. When one controller is installed, this procedure is only applied to Controller 0 (CM#0).
1 Connect the LAN cable to the ETERNUS DX.
Connect the LAN cable connectors to the MNT ports of the Controller 0 (CM#0) and Controller 1 (CM#1)
for the ETERNUS DX.
• When connecting the LAN cables, position them so that they will not obstruct
replacement of the power supply unit or controllers by the maintenance engi-
neer.
2 When the RMT port is used, connect the connector of the LAN cable to the RMT port of Controller 0
(CM#0) and Controller 1 (CM#1).
3 Connect the LAN cables of the MNT port to the network of the customer. If the RMT port is used for
remote support, connect the LAN cable of the RMT port to the network for remote support.
5.6 Firewall Settings
Set the firewall for each service. The settings are required respectively for the MNT port and the RMT port.
Chapter 5 General Settings
5.6 Firewall Settings
68
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0
To Next Page
Loading...
