•
If both HTTP connection and HTTPS connection are disabled, the device is inaccessible via ETERNUS Web
GUI.
•
If both Telnet connection and SSH connection are disabled, the device is inaccessible via ETERNUS CLI.
•
If the network environment for the MNT port is not set up, some functions will be unusable. Make sure
to set up the network environment.
1 Start the Web browser and log in to ETERNUS Web GUI with the IP address that is set in Step 6 in
"5.4 Storage Management (Initial Setup 1)
" (page 62).
2 Click the [System] tab on the navigation of the ETERNUS Web GUI screen.
3 In [Category], click [Network].
The [Network] screen appears.
4 Select the port to be set. In [Action], click [Setup Firewall].
Chapter 5 General Settings
5.6 Firewall Settings
69
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0
To Next Page
Loading...
