Fujitsu ETERNUS DX60 S3 - Copy Data Destination Volume (SDPV) Creation; Figure 5.10 Copy Data Destination Volume (SDPV) Creation

A confirmation screen appears.
4 Click the [OK] button.
The volume is created and the registration completion screen appears.
5 Click the [Done] button.
The screen display returns to the [Volume] screen.
5.7.4 Copy Data Destination Volume (SDPV) Creation
Create a copy data destination volume in the backup RAID group.
Create a volume as an expansion area of SDV in the backup RAID group "RG1" created in "5.7.1 RAID Group
Creation" (page 71).
Figure 5.10 Copy Data Destination Volume (SDPV) Creation
Copy data destination volume
sdpv
(Snap Data Pool Volume)
500GB
Backup RAID group (RG1)
RAID5(2+1)
2TB
2TB
2TB
Chapter 5 General Settings
5.7 RAID Configuration Settings
76
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0