Fujitsu ETERNUS DX60 S3 - PC Terminal Connection; Figure 5.2 Example of Creating Operation Volume and Backup Volume

● ETERNUS DX Environment
Create the operation volume and backup volume in the ETERNUS DX.
Figure 5.2 Example of Creating Operation Volume and Backup Volume
ETERNUS DX
RAID group 0 (RAID5)
600GB × 5
RAID group 1 (RAID5)
2TB × 3
Standard
Snap Data Volume (SDV) (*1)
Snap Data Pool Volume (*2)
1TB
500GB
Generation management volume
Operation volume
Copy data destination volume
sdv0
sdpv
main
sdv1 sdv2 sdv3 sdv4 sdv5 sdv6
*1: SDV is used as the copy destination for SnapOPC+ and stores generation data.
*2: SDPV is the expansion area of the SDV and is used to configure the Snap Data Pool (SDP) area.
5.1 PC Terminal Connection
Connect a PC terminal to the ETERNUS DX.
Connect the PC terminal to the RMT port of Controller 0 (CM#0) on the controller enclosure directly with the
LAN cable (for operation management).
For the setup information of the PC terminal, refer to "3.3 Preparing the PC Terminal for Setup
" (page 42).
Chapter 5 General Settings
5.1 PC Terminal Connection
57
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0