Fujitsu ETERNUS DX60 S3 - Figure 11.1 Solution - Green

Figure 11.1 Solution — Green
Business drives
Backup drives
Collects power consumption
and temperature data
for each storage system
Server
ETERNUS SF
Storage Cruiser
During operation
Business drives
Backup drives
During backup
12
PM
Off
Operates
for only four hours
Backup volume
operation
Off
12
On
AM
4
ETERNUS DX
Stopped Stopped Stopped Stopped Stopped
■
Configuration Procedure
Perform the required settings for Eco-mode. These settings can be performed with either ETERNUS SF Storage
Cruiser or ETERNUS Web GUI.
To set the visualization of power consumption and temperature, use ETERNUS SF Storage Cruiser. ETERNUS SF
Storage Cruiser obtains power consumption of the ETERNUS DX for "power consumption" and ambient tem-
perature (intake air temperature for the fans) for "temperature".
● Required Environment
ETERNUS SF Storage Cruiser is required to visualize (graphically display) the power consumption and temper-
ature.
● Configuration Procedure
Eco-mode
Perform the following settings with the operation management server (ETERNUS SF Storage Cruiser) or ETER-
NUS Web GUI:
•
Eco-mode setup
Enable the Eco-mode for the ETERNUS DX.
Chapter 11 Solution Configuration
11.1 Green
153
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0