6 Shut down the server.
After this, the settings for the ETERNUS DX must be completed before connecting the ETERNUS DX to
the server. In order to perform these settings, turn off the server.
3.3 Preparing the PC Terminal for Setup
The initial settings are performed by using a Web browser on the PC terminal.
Prepare and set up the PC terminal before the initial settings.
Preparing the PC terminal
Prepare the PC terminal that contains the following environment:
•
Web browser
Usable Web browsers are shown below. Using Web browsers other than the following is possible, but prop-
er operation is not guaranteed.
-
Microsoft Internet Explorer 7.0, 8.0, 9.0, 10.0 (desktop version), 11.0 (desktop version)
-
Mozilla Firefox 3.6.x, ESR 10.0.x, ESR 17.0.x, ESR 24.0.x
Setting up the PC terminal
Set up the PC terminal with the following procedure:
1 Set the IP address and subnet mask of the PC terminal.
Set the following values.
IP address: 192.168.1.2
Subnet mask: 255.255.255.0
2 Check the settings of the Web browser.
For details on the required settings, refer to "Configuration Guide (Web GUI)".
Chapter 3 Checking the Configuration Environment
3.3 Preparing the PC Terminal for Setup
42
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0
To Next Page
Loading...
