The procedure to create a copy data destination volume (SDPV) is as follows:
1 Click the [Volume] tab on the navigation of the ETERNUS Web GUI screen.
The [Volume] screen appears.
2 In [Action], click [Create].
The [Create Volume] screen appears.
3 Set the required items in the [Create Volume] screen and click the [Create] button.
Name: sdpv
Capacity: 500GB
Type: Snap Data Pool Volume
RAID Group / TPP Selection: Manual
Manual Setting: RG1
A confirmation screen appears.
4 Click the [OK] button.
The volume is created and the registration completion screen appears.
5 Click the [Done] button.
The screen display returns to the [Volume] screen.
Chapter 5 General Settings
5.7 RAID Configuration Settings
77
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0
To Next Page
Loading...
