1 Click the [Advanced Copy] tab on the navigation of the ETERNUS Web GUI screen. Then, click [Setting]
in [Category].
2 In [Action] on the [Setting] screen, click [Modify EC/OPC Priority].
3 Set the required items and click the [Set] button.
• Resolution
Select the resolution. Specify "´64" in this example.
• Table Size (MB)
Specify the copy table size. Specify "128 (MB)" in this example.
• Table Size Threshold
Select the threshold for the table size usage rate.
To send notification automatically when the usage rate exceeds the threshold, enable notification in
"
6.1 Event Notification Setup" (page 81) and specify the notification method (email, SNMP, trap, or
Syslog).
4 In the confirmation screen, click the [OK] button.
Copy table size setting starts.
5 In the setting completion screen, click the [Done] button.
The screen display returns to the [Setting (Advanced Copy)] screen.
Chapter 9 Advanced Copy Settings
9.1 Advanced Copy Basic Settings
139
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0
To Next Page
Loading...
