Fujitsu ETERNUS DX60 S3 - Page 27

3 Install the power distribution unit in the rack.
Fasten the power distribution unit to the bracket with the two M3 screws removed in Step 1.
(Rack pillar: rear)
M3 screw
M3 screw
4 Attach the blank panel to the front side of the rack.
The blank panel should be attached at the same height as the power distribution unit.
(Rack pillar: rear)
(Rack pillar: front)
Blank panel
Power distribution unit
Chapter 2 Rack Installation
2.1 Installing Power Distribution Unit (for Regions Other than EMEA&I)
27
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0