When connecting the mini SAS HD cable between enclosures, check the direction of the connector (the tab
must be pointed downward) and firmly insert all the way in.
To disconnect the mini SAS HD cable between enclosures, hold the tab and then pull out the connector.
1 Check the connection destination of the mini SAS HD cables between enclosures.
• The connectors on the cable with the "n" symbol are connected to the DI (OUT) ports on the controller
enclosure.
• The connectors on the cable with the "l" symbol are connected to the DI (IN) ports on the drive en-
closure.
Chapter 4 Connecting Cables
4.2 Drive Enclosure Connection
48
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0
To Next Page
Loading...
