The procedure to create an operation volume is as follows:
1 Click the [Volume] tab on the navigation of the ETERNUS Web GUI screen.
The [Volume] screen appears.
2 In [Action], click [Create].
The [Create Volume] screen appears.
3 Set the required items in the [Create Volume] screen and click the [Create] button.
Name: main
Capacity: 1TB
Type: Standard
RAID Group / TPP Selection: Manual
Manual Setting: RG0
A confirmation screen appears.
4 Click the [OK] button.
The volume is created and the registration completion screen appears.
5 Click the [Done] button.
The screen display returns to the [Volume] screen.
6 Then, create SDV and SDPV in the backup RAID group (RG1).
For the creation procedure, refer to "5.7.3 Generation Management Volume (SDV) Creation
" (page 75)
and "5.7.4 Copy Data Destination Volume (SDPV) Creation" (page 76).
Chapter 5 General Settings
5.7 RAID Configuration Settings
74
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-9002-01ENZ0
To Next Page
Loading...
