Index
Chapter 6 Replacing Consumables
Appendix
Glossary
Introduction
Contents
TOP
101
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing
Consumables
6 Close the ADF.
For information on how to close the ADF, refer to "1.5 Opening/
Closing the ADF" (page 19).
7 Reset the brake roller counter.
Reset the counter by one of the following methods.
Select [23: Show/Clear Counters] from [Main Menu] on the
operator panel, then reset the counter.
For more details, refer to "3.2 Main Menu" (page 50).
Start up the Software Operation Panel and reset the counter.
For more details, refer to "Resetting the counters" (page 146).
Be careful not to have your fingers caught
when the ADF closes.
Do not close the ADF while the roller cover is open.
Confirm that the brake roller is installed properly.
When the brake roller is not installed properly, it
causes feeding errors such as paper jams.
To Next Page
Loading...
