Fujitsu fi-6800 - 8.5 Settings Related to Multifeed Detection

Index
Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
170
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Specifying a multifeed detection method
[Multifeed]
Multifeed is an error when two or more sheets are fed through
the ADF at once. It is also called a “multifeed” when a different
document length is detected.
Not noticing multifeed errors while scanning may put you in a
situation where important data are missing from the scanned
images. Multifeed detection function is equipped to prevent
such troubles.
When this function is enabled, an error message is displayed
as soon as it detects a multifeed, and stops the scan.
Note that multifeeds cannot be detected in the area of 15 mm
from the leading edge of the document.
1 Start up the Software Operation Panel.
Refer to "8.1 Starting Up the Software Operation Panel" (page 132).
2 From the listing on the left, click [Device Setting 2] 
[Multifeed].
8.5 Settings Related to Multifeed Detection