Fujitsu fi-6800 - Setting the Waiting Time to Enter Power Saving Mode [Power Saving]

Index
Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
178
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Setting the Waiting Time to Enter Power Saving
Mode [Power saving]
When the scanner is not being used for a certain period of
time, it enters power saving mode to save the power
consumption.
1 Start up the Software Operation Panel.
Refer to "8.1 Starting Up the Software Operation Panel" (page 132).
2 From the listing on the left, select [Device Setting].
3 Use the slide bar to specify the waiting time to enter
power saving mode.
It can be set in the range of 5 to 235 minutes (in increments of
5 minutes).
When you select the [Power off after a certain period of
time] check box, the scanner will turn itself off
automatically if it is turned on and left unused for the set
time. The time until power-off can be selected from 1/2/4/
8 hours.