Fujitsu fi-6800 - Situation in Which the Document Is Not Fed into the ADF Occur Frequently

Index
Introduction
Chapter 7 Troubleshooting
Appendix
Glossary
Contents
TOP
124
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Operational
Settings
Replacing
Consumables
Scanner
Overview
Troubleshooting
Situation in which the document is not fed into
the ADF occur frequently.
*1: "Consumables" refers to the pick roller, separator roller and brake roller.
Does the condition of the documents fulfill the
requirements described in "Precautions" in "Paper Quality"
(page 37)?
No
Use a document that satisfies the required conditions.
For more details, refer to "2.2 Documents for Scanning" (page 37).
Ye s
Did you fan the documents before loading them on the
hopper?
No
Fan the documents before loading, or reduce the amount of sheets.
Ye s
Are the consumables (*1) installed correctly?
No
Install the consumables (*1) correctly.
For information on how to install the consumables, refer to "Chapter 6 Replacing
Consumables" (page 93).
Ye s
Are any of the consumables (*1) dirty?
Ye s
Clean the consumables (*1).
For more details, refer to "5.2 Cleaning the ADF (with Cleaning Sheet)" (page 84)
or "5.3 Cleaning the ADF (with cloth)" (page 86)
No
Are any of the consumables (*1) worn out?
Ye s
Check the Consumables Counter. Replace the consumables if necessary.
For information on how to replace the consumables, refer to "Chapter 6 Replacing
Consumables" (page 93).
No
If the above countermeasures do not solve the problem, check the items in "7.4
Before You Contact the Scanner Service Provider" (page 128) first, then contact
your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider.