Fujitsu fi-6800 - 4.2 Scanning Documents of Different Types and Sizes

Index
Chapter 4 Various Ways to Scan
Appendix
Glossary
Introduction
Contents
TOP
70
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
Various Ways
to Scan
How to Use
the Operator
Panel
Scanning Documents of Different Widths
When you scan a batch of documents with different widths,
load the documents using the following procedure:
1 Align the edges of the documents.
 Align by the center
 Align by the side
2 Place the documents on the hopper and adjust the hopper
side guides to the widest document in the batch.
For information on how to load documents on the hopper, refer to "2.1
Loading Documents" (page 31).
4.2 Scanning Documents of Different Types and Sizes
 When you scan documents of different widths at the same
time, some of the smaller documents may be skewed or
may not be fed into the scanner. Try to scan documents of
the same width.
 For more details about the conditions of scanning
documents in mixed batches, refer to "Scanning a Mixed
Batch of Documents" (page 43).
Make sure that all documents are placed underneath the
pick roller, otherwise the document will not be picked.
 Good example
 Bad example
Pick Roller
Pick Roller