Index
Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
168
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Adjusting the Result of the Output Image
[Overcrop/Undercrop]
You can adjust the output image result for documents detected
in Automatic Page Size Detection.
1 Start up the Software Operation Panel.
Refer to "8.1 Starting Up the Software Operation Panel" (page 132).
2 From the listing on the left, click [Device Setting 2]
[Overcrop/Undercrop].
3 Adjust the output result by using the slider bar.
Item Description
Overcrop Adds black areas around the edges of the document
so that it contains the whole image.
Specify in the range of 0 to 5 mm (in increments of 1
mm).
Undercrop Deletes the area around the edges of the document
and leaves no black area.
Specify in the range of -5 to 0 mm (in increments of 1
mm).
When you scan a wide document by Overcrop, it may not
add the specified amount of black area around the
document edge.
Output result is not adjusted when the slide bar is set
to 0 mm.
This setting appears ONLY when Kofax VRS (optional)
is used.
To Next Page
Loading...
