Fujitsu fi-6800 - Basic Flow of Scanning Operation

Index
Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Contents
TOP
27
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
This section explains about the basic flow of scanning
operations.
In order to perform a scan, you need a scanner driver and an
application that supports the scanner driver.
The following scanner drivers and image scanning
applications are bundled with the scanner:
 Scanner driver
- PaperStream IP (TWAIN) driver
Conforms to the TWAIN standard. Used when you operate the
scanner using TWAIN-compliant 32-bit applications.
- PaperStream IP (TWAIN x64) driver
Conforms to the TWAIN standard. Used when you operate the
scanner using TWAIN-compliant 64-bit applications.
- PaperStream IP (ISIS) driver
Conforms to the ISIS standard. Used when you operate the
scanner using ISIS-compliant applications.
 Image Scanning Application
- PaperStream Capture
Supports the PaperStream IP (TWAIN) driver and the
PaperStream IP (ISIS) driver
1 Turn on the scanner.
For information on how to turn on the power, refer to "1.3 Turning the
Power ON/OFF" (page 16).
2 Load documents on the hopper.
Set the documents with the front side (scanning side) facing up.
For information on how to load documents, refer to "Chapter 2 How to
Load Documents" (page 30).
1.11 Basic Flow of Scanning Operation
 For details about the scanner driver, refer to the
PaperStream IP driver Help.
 For details about the image scanning application, refer to
the PaperStream Capture Help.
 When connected via SCSI, turn on the scanner and
confirm that [Ready] is displayed on the LCD before
you turn on the computer.
 When switching the connectors, make sure to power
off the scanner and the computer first.